Product Description
Ford AOD, FIOD New As-Cast Aluminum Deep Transmission Pan.
Volume: 2.0 qts. over stock for AOD transmissions.
Dimensions: Click here for dimensions.
Number of Bolts: 14
The design of this transmission pan has been revised to allow it to work with the Ford reusable gasket. You can also use any aftermarket gasket that is designed to work with the stock pan.
Filter requirements for this pan:
- AOD – 4WD (Deep) filters are recommended.
Transmission Pan Features
- Increased oil capacity for cooler temperatures
- Sand-cast aluminum with raised fins
- 3/16-inch thick wall construction to add strength to the transmission case
- 3/8-inch thick gasket flange will not bend when bolts are tightened
- Machined gasket surface for a secure seal
- Boss cast into pan can be machined for a temperature sensor
- Magnetic drain plug for easier, less messy maintenance
- Mounting hardware provided
Gasket and filter not included (use stock parts).
What is the difference between AOD and AODE, 4R70, 4R75 Transmissions?
The transmission pan bolt pattern for the AOD is slightly different than that of the AODE, 4R70, 4R75. It is important that you identify which transmission you have so that the pan you order will have the correct bolt pattern.
The AOD transmission was used in many rear wheel drive Ford vehicles from late 1981 through early 1993. The AODE transmission was produced for model years 1993 and 1994. Production of the 4R70 also began in 1993 and by 1995 it replaced the AODE. The 4R75 designation began in 2003.
AODE, 4R70, and 4R75 transmissions have a large electrical connector on the passenger side of the transmission just above the transmission pan. They also have a neutral safety switch mounted on the selector shaft on the outside of the transmission case on the driver’s side just above the transmission pan.
AOD transmissions have an internal neutral safety switch. A cable connects the throttle body to the transmission to downshift the transmission on full throttle acceleration. The AODE, 4R70, 4R75 do this electronically.
Remember: To order the proper pan to get the correct bolt pattern on your pan.
Filters for PML AOD, AODE, 4R70, 4R75 Transmission Pans
PML makes deep and low profile transmission pans for Ford AOD, AODE, 4R70, and 4R75 transmissions. You must get the correct filter for the pan you order.
For the deep pan:
AOD – 4WD (Deep) filters are recommended.
DUE TO THE HIGH DEMAND OF THESE PANS THERE MAY BE A ONE TO THREE WEEK BACK ORDER, SO PLEASE CALL OR EMAIL PRIOR TO YOUR PURCHASE TO CHECK STOCK. THANK YOU!!!
